Meropenem And Sodium Chloride
PrescriptionTên thương mại: Meropenem and Sodium Chloride
About This Medication
11 DESCRIPTION Meropenem for injection is a sterile, pyrogen-free, synthetic, carbapenem antibacterial drug for intravenous administration. Meropenem is (4 R ,5 S ,6 S )-3- [[(3 S ,5 S )-5-(Dimethylcarbamoyl)-3-pyrrolidinyl]thio]-6-[(1 R )-1-hydroxyethyl]-4-methyl-7-oxo-1-azabicyclo[3.2.0]hept-2-ene-2-carboxylic acid trihydrate. Its empirical formula is C 17 H 25 N 3 O 5 S•3H 2 O with a molecular weight of 437.52. Its structural formula is: Meropenem for injection is a white to pale yellow crystalline powder containing meropenem trihydrate and sodium carbonate. The constituted solution varies from colorless to yellow depending on the concentration. The pH of freshly constituted solutions is between 7.3 and 8.3. Meropenem is soluble in 5% monobasic potassium phosphate solution, sparingly soluble in water, very slightly soluble in hydrated ethanol, and practically insoluble in acetone or ether. Meropenem for Injection USP and Sodium Chloride Injection USP is supplied as a sterile, nonpyrogenic, single-dose packaged combination of meropenem (drug chamber) and 50 mL of sodium chloride (diluent) in the DUPLEX ® sterile container. When reconstituted as instructed, each 1 gram Meropenem for injection in the DUPLEX ® Container will deliver 1 gram of meropenem and a total sodium content of 290.2 mg (12.6 mEq). Each 500 mg Meropenem for injection in the DUPLEX ® Container will deliver 500 mg of meropenem and a total sodium content of 245.1 mg (10.7 mEq) [see Dosage and Administration (2.4) ]. The osmolality of the reconstituted solution of Meropenem for Injection USP and Sodium Chloride Injection USP is approximately 356 mOsmol/kg for the 500 mg dose and approximately 417 mOsmol/kg for the 1 gram dose. The DUPLEX ® Container is a flexible dual chamber container. After removing the peelable foil strip, activating the seals, and thoroughly mixing, the reconstituted drug product is hyperosmotic and is intended for single intravenous use. The product (diluent and drug) contact layer is a mixture of thermoplastic rubber and a polypropylene ethylene copolymer that contains no plasticizers. Not made with natural rubber latex, PVC or Di(2-ethylhexyl)phthalate (DEHP). structural formula
Hoạt chất
| Thành phần | Hàm lượng |
|---|---|
| Meropenem | - |
Chỉ định & Cách dùng
Cơ chế hoạt động
Liều dùng & Cách dùng
Side Effects Overview
Cảnh báo & Thận trọng
5 WARNINGS AND PRECAUTIONS Serious and occasionally fatal hypersensitivity (anaphylactic) reactions have been reported in patients receiving beta-lactams. ( 5.1 ) Severe cutaneous adverse reactions have been reported in patients receiving meropenem intravenous. Discontinue meropenem immediately if patients experience these signs and symptoms and consider alternative treatment. ( 5.2 ) Rhabdomyolysis: If signs or symptoms of rhabdomyolysis are observed, discontinue Meropenem for Injection and Sodium Chloride Injection and initiate appropriate therapy. ( 5.3 ) Seizures and other adverse CNS experiences have been reported during treatment. ( 5.4 ) Co-administration of Meropenem for Injection with valproic acid or divalproex sodium reduces the serum concentration of valproic acid potentially increasing the risk of breakthrough seizures. ( 5.5 , 7.2 ) Clostridioides difficile- associated diarrhea (ranging from mild diarrhea to fatal colitis) has been reported. Evaluate if diarrhea occurs. ( 5.6 ) In patients with renal dysfunction, thrombocytopenia has been observed. ( 5.9 ) Solutions containing sodium ions should be used with great care, if at all, in patients where the administration of sodium could be detrimental. ( 5.11 ) 5.1 Hypersensitivity Reactions Serious and occasionally fatal hypersensitivity (anaphylactic) reactions have been reported in patients receiving therapy with beta-lactams. These reactions are more likely to occur in individuals with a history of sensitivity to multiple allergens. There have been reports of individuals with a history of penicillin hypersensitivity who have experienced severe hypersensitivity reactions when treated with another beta-lactam. Before initiating therapy with Meropenem for Injection and Sodium Chloride Injection, it is important to inquire about previous hypersensitivity reactions to penicillins, cephalosporins, other beta-lactams, and other allergens. If an allergic reaction to Meropenem for Injection and Sodium Chloride Injection occurs, discontinue the drug immediately. 5.2 Severe Cutaneous Adverse Reactions Severe cutaneous adverse reactions (SCAR) such as Stevens-Johnson syndrome (SJS), toxic epidermal necrolysis (TEN), drug reaction with eosinophilia and systemic symptoms (DRESS), erythema multiforme (EM) and acute generalized exanthematous pustulosis (AGEP) have been reported in patients receiving meropenem [see Adverse Reactions (6.2) ] . If signs and symptoms suggestive of these reactions appear, Meropenem for Injection and Sodium Chloride Injection should be withdrawn immediately and an alternative treatment should be considered. 5.3 Rhabdomyolysis Rhabdomyolysis has been reported with the use of meropenem [see Adverse Reactions (6.2)] . If signs or symptoms of rhabdomyolysis such as muscle pain, tenderness or weakness, dark urine, or elevated creatine phosphokinase are observed, discontinue Meropenem for Injection and Sodium Chloride Injection and initiate appropriate therapy. 5.4 Seizure Potential Seizures and other adverse CNS experiences have been reported during treatment with meropenem for injection. These experiences have occurred most commonly in patients with CNS disorders (e.g., brain lesions or history of seizures) or with bacterial meningitis and/or compromised renal function [see Adverse Reactions (6.1) and Drug Interactions (7.2) ]. During clinical investigations, 2904 immunocompetent adult patients were treated for non-CNS infections with the overall seizure rate being 0.7% (based on 20 patients with this adverse event). All meropenem-treated patients with seizures had pre-existing contributing factors. Among these are included prior history of seizures or CNS abnormality and concomitant medications with seizure potential. Dosage adjustment is recommended in patients with advanced age and/or adult patients with creatinine clearance of 50 mL/min or less [see Dosage and Administration (2.2) ]. Close adherence to the recommended dosage regimens is urged, especially in patients with known factors that predispose to convulsive activity. Anti-convulsant therapy should be continued in patients with known seizure disorders. If focal tremors, myoclonus, or seizures occur, evaluate neurologically, place on anti-convulsant therapy if not already instituted, and re-examine the dosage of Meropenem for Injection and Sodium Chloride Injection to determine whether it should be decreased or discontinued. 5.5 Risk of Breakthrough Seizures Due to Drug Interaction with Valproic Acid The concomitant use of meropenem and valproic acid or divalproex sodium is generally not recommended. Case reports in the literature have shown that co-administration of carbapenems, including meropenem, to patients receiving valproic acid or divalproex sodium results in a reduction in valproic acid concentrations. The valproic acid concentrations may drop below the therapeutic range as a result of this interaction, therefore increasing the risk of breakthrough seizures. Increasing the dose of valproic acid or divalproex sodium may not be sufficient to overcome this interaction. Consider administration of antibacterial drugs other than carbapenems to treat infections in patients whose seizures are well controlled on valproic acid or divalproex sodium. If administration of Meropenem for Injection and Sodium Chloride Injection is necessary, consider supplemental anti-convulsant therapy [see Drug Interactions (7.2) ]. 5.6 Clostridioides difficile –Associated Diarrhea Clostridioides difficile- associated diarrhea (CDAD) has been reported with use of nearly all antibacterial agents, including meropenem for injection, and may range in severity from mild diarrhea to fatal colitis. Treatment with antibacterial agents alters the normal flora of the colon leading to overgrowth of C. difficile . C. difficile produces toxins A and B which contribute to the development of CDAD. Hypertoxin producing isolates of C. difficile cause increased morbidity and mortality, as these infections can be refractory to antimicrobial therapy and may require colectomy. CDAD must be considered in all patients who present with diarrhea following antibacterial drug use. Careful medical history is necessary since CDAD has been reported to occur over two months after the administration of antibacterial agents. If CDAD is suspected or confirmed, ongoing antibacterial drug use not directed against C. difficile may need to be discontinued. Appropriate fluid and electrolyte management, protein supplementation, antibacterial drug treatment of C. difficile, and surgical evaluation should be instituted as clinically indicated. 5.7 Development of Drug-Resistant Bacteria Prescribing Meropenem for Injection and Sodium Chloride Injection in the absence of a proven or strongly suspected bacterial infection or a prophylactic indication is unlikely to provide benefit to the patient and increases the risk of the development of drug-resistant bacteria. 5.8 Overgrowth of Nonsusceptible Organisms As with other broad-spectrum antibacterial drugs, prolonged use of meropenem may result in overgrowth of nonsusceptible organisms. Repeated evaluation of the patient is essential. If superinfection does occur during therapy, appropriate measures should be taken. 5.9 Thrombocytopenia In patients with renal impairment, thrombocytopenia has been observed but no clinical bleeding reported [see Dosage and Administration (2.2) , Adverse Reactions (6.1) , Use In Specific Populations (8.5) and (8.6) , and Clinical Pharmacology (12.3) ]. 5.10 Potential for Neuromotor Impairment Alert patients receiving meropenem for injection on an outpatient basis regarding adverse events such as seizures, delirium, headaches and/or paresthesias that could interfere with mental alertness and/or cause motor impairment. Until it is reasonably well established that meropenem for injection is well tolerated, advise patients not to operate machinery or motorized vehicles [see Adverse Reactions (6.1) ]. 5.11 High Sodium Load Each 500 mg of Meropenem for Injection and Sodium Chloride Injection delivers 245.1 mg (10.7 mEq) of sodium and each 1 gram of Meropenem for Injection and Sodium Chloride Injection delivers 290.2 mg (12.6 mEq) of sodium. Avoid use of Meropenem for Injection and Sodium Chloride Injection in patients with congestive heart failure, elderly patients and patients requiring restricted sodium intake.
Chống chỉ định
4 CONTRAINDICATIONS Meropenem for Injection and Sodium Chloride Injection is contraindicated in patients with known hypersensitivity to any component of this product or to other drugs in the same class or in patients who have demonstrated anaphylactic reactions to beta-lactams. Known hypersensitivity to product components or anaphylactic reactions to beta-lactams. ( 4 ) Contraindicated where the administration of sodium or chloride could be clinically detrimental. ( 4 )
Dược động học
Frequently Asked Questions
1 INDICATIONS AND USAGE Meropenem for Injection and Sodium Chloride Injection is a penem antibacterial indicated for the treatment of: Complicated skin and skin structure infections (adult patients and pediatric patients 3 months of age and older requiring the full adult dose only). ( 1.1 ) Complicated intra-abdominal infections (adult patients and pediatric patients 3 months of age and older requiring the full adult dose only). ( 1.2 ) Bacterial meningitis (pediatric patients 3 months of age and older requiring …
2 DOSAGE AND ADMINISTRATION Use this formulation of meropenem only in patients who require the entire 500 mg or 1 gram dose and not any fraction thereof. ( 2.1 ) 500 mg every 8 hours by intravenous infusion over 15 to 30 minutes for complicated skin and skin structure infections (cSSSI) for adult patients. When treating infections caused by Pseudomonas aeruginosa , a dose of 1 gram every 8 hours is recommended ( 2.1 ). 1 gram every 8 hours …
5 WARNINGS AND PRECAUTIONS Serious and occasionally fatal hypersensitivity (anaphylactic) reactions have been reported in patients receiving beta-lactams. ( 5.1 ) Severe cutaneous adverse reactions have been reported in patients receiving meropenem intravenous. Discontinue meropenem immediately if patients experience these signs and symptoms and consider alternative treatment. ( 5.2 ) Rhabdomyolysis: If signs or symptoms of rhabdomyolysis are observed, discontinue Meropenem for Injection and Sodium Chloride Injection and initiate appropriate therapy. ( 5.3 ) Seizures and other adverse CNS experiences …
4 CONTRAINDICATIONS Meropenem for Injection and Sodium Chloride Injection is contraindicated in patients with known hypersensitivity to any component of this product or to other drugs in the same class or in patients who have demonstrated anaphylactic reactions to beta-lactams. Known hypersensitivity to product components or anaphylactic reactions to beta-lactams. ( 4 ) Contraindicated where the administration of sodium or chloride could be clinically detrimental. ( 4 )
Meropenem And Sodium Chloride is a prescription medication. You will need a valid prescription from a licensed healthcare provider.
Similar Injection Products
Browse all Injection products →References & Data Sources
- • DailyMed — Meropenem And Sodium Chloride drug label (National Library of Medicine)
- • openFDA — Meropenem And Sodium Chloride label data (U.S. Food & Drug Administration)
- • RxNorm — RXCUI 1722934 (NLM Normalized Drug Names)
- • NDC Directory — Meropenem And Sodium Chloride (FDA National Drug Code)
Tuyên bố miễn trách nhiệm y tế
Thông tin trên trang này chỉ nhằm mục đích giáo dục và không nên được sử dụng thay thế cho lời khuyên y tế chuyên nghiệp, chẩn đoán hoặc điều trị.
Luôn tìm kiếm lời khuyên của bác sĩ hoặc nhà cung cấp dịch vụ y tế có chuyên môn khác đối với bất kỳ câu hỏi nào bạn có về tình trạng bệnh hoặc thuốc.
Nguồn dữ liệu: DailyMed (NLM), openFDA, MFDS